Setup Instructions; Important - Intex CS3220 Manual Del Propietário

SETUP INSTRUCTIONS

• The Saltwater System requires a separate filter pump [300~1000 gph (1136~3785 lph)]
to drive the water and function properly.
• The Saltwater System must be installed as the last piece of pool equipment in the
water return line to the pool as displayed below. This location extends the life of the
titanium plates.
• Remove any large debris and particles such as leaves, sand, insects and bugs from
the pool water first.
1. Assemble the above-ground-pool (AGP) and its filter pump according to their installation
instructions.
2. Take the Saltwater System and its accessories out of the packaging.
3. Place the Saltwater System in line after the filter pump.
4. Connect the connector hose (2) to the Saltwater System inlet with a hose clamp (3).
5. Go directly to step 6 if your pool is empty. If your above-ground-pool is filled with water,
unscrew the strainer grids from the strainer connectors and insert the black hat-like plugs
into the connectors, before installing the saltwater pool system.
6. Disconnect the water return hose from the filter pump connection and connect it to the
Saltwater System outlet.
7. Connect the connector hose (2) to the filter pump outlet connection with a hose clamp (3).
Tighten securely.
8. Remove the black hat-like plugs that prevent water from flowing out of the pool. Now, return
the strainer grids to the strainer connectors.
wATER TO
POOL
ID 1-1/4" (32mm)
PUMP HOSE
SAVE THESE INSTRUCTIONS
(133IO) SaltwatEr SyStEm ENGlISH 7.5" X 10.3" PaNtONE 295U 07/21/2020

IMPORTANT

SwIMMING POOL
3
ID 1-1/4" (32mm)
CONNECTOR HOSE
SALTwATER
SYSTEM
wATER FROM
POOL
FILTER
PUMP
2 ID 1-1/4" (32mm)
PUMP HOSE
133
English
A
Page 5