Inserting Or Replacing The Gobo - Linde Warnprojektor 45 Instrucciones Originales

4
Operation

Inserting or replacing the gobo

Inserting or replacing the gobo
WARNING
Risk of burns due to hot sleeve.
Before working on the warning projector, discon-
nect the power supply.
Allow the warning projector to cool down.
 Loosen the sleeve (1) by turning it in an
anticlockwise direction and remove it
carefully.
 Loosen the knurled-head screw M4 (2).
 Remove the gobo holder (3).
 1. Separate the two parts of the gobo holder
by unscrewing them in an anti-clockwise
direction.
 2. Insert or replace the gobo so that the
image is back-to-front.
 3. Screw together the two parts of the gobo
holder in a clockwise direction.
CAUTION
Damage to the gobo after inserting the gobo holder.
Do not tighten the knurled-head screw too securely.
 Re-insert the gobo holder and carefully
tighten the knurled-head screw until the
gobo holder is secured in place.
12
3
1.
2.
3.
Operating Instructions – 3008011680 EN – 06/2018
2
1
LWP_06
LWP_07