Focusing The Warning Pictogram; Aligning The Warning Pictogram - Linde Warnprojektor 45 Instrucciones Originales

Focusing the warning
pictogram
 Loosen the sleeve in an anticlockwise
direction and remove it carefully.
 Switch on the device.
 Loosen the knurled-head screw M4 (1).
 Move the lens (2) until the warning pic-
togram is in focus.
 Tighten the knurled-head screw.
Aligning the warning pic-
togram
 Loosen the sleeve in an anticlockwise
direction and remove it carefully.
 Switch on the device.
 Loosen the knurled-head screw M4 (1).
 Move the warning pictogram into the
required position by turning the gobo holder
(2).
CAUTION
Damage to the gobo.
Do not tighten the knurled-head screw too securely.
 Carefully tighten the knurled-head screw
until the gobo holder is secured in place.
Operating Instructions – 3008011680 EN – 06/2018
Operation

Focusing the warning pictogram

1
2
4
LWP_08
1
2
LWP_09
13