Publicidad
Idiomas disponibles
Idiomas disponibles
Commissioning:
» Check SMARTWELD RECORD and its components for signs of damage.
» Status of the SMARTWELD RECORD can be checked using the LED lamps
» Check that all threaded connections and seals are clean and undamaged.
» The connection of hoses
for the SMARTWELD RECORD must be carried out in accordance with the
operating instructions for autogenous devices and the THERMIT
process.
» Briefly press the button
hold the button
» Launch the SMARTWELD APP and proceed with the working steps as set out in
the SMARTWELD APP operating instructions.
LED lamp
Description
Bluetooth connection is established between the
Lit in blue
SMARTWELD RECORD and the SMARTWELD APP.
Lit in green
The charging cable is connected.
The SMARTWELD RECORD is switched on.
Flashing red
Bluetooth connection between the SMARTWELD RECORD
and the SMARTWELD APP is not yet established.
The Batteries are almost empty. Connect the charging
Lit in red
cable and charge the SMARTWELD RECORD.
Danger! Ensure that all parts coming into contact with oxygen are free of
oil and grease! Danger of explosion!
When installing the burner insert on the SMARTWELD RECORD, ensure
the parts and seals are clean and undamaged. The terminal nut on the
torch insert should be tightened by hand. If necessary, a key can be used.
Use in combination with competitor products is not permitted.
The SMARTWELD RECORD must always be operated in technically perfect
condition. If the SMARTWELD RECORD is not in perfect condition, restore
normal condition and/or inform the authorised service partner.
and selection of suitable preheating burner insert
to start up the SMARTWELD RECORD. Press and
for several seconds to switch off the device.
.
welding
®
5 5
Publicidad
