FCC COMPLIANCE AND ADVISORY STATEMENT
This hardware device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed or used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna;
2) Increase the separation between the equipment and the receiver;
3) Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected;
4) Consult the dealer or an experienced radio/TV technician for help. Any changes or
modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. Where shielded interface cables have been
provided with the product or specified additional components or accessories elsewhere
defined to be used with the installation of the product, they must be used in order to ensure
compliance with FCC regulations.
This digital device does not exceed the Class B limits for radio noise emissions from digital
apparatus specified in the interference-causing equipment standard entitled "Digital Apparatus,"
ICES-003 of the Department of Communications.
This device complies with RSS-210 of Industry and Science Canada. Operation is subject to the
following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
ADDEMDUM TO USERS MANUEL
CANADIAN DOC STATEMENT