Troubleshooting - Hoover PORTAPOWER CH30000 Manual Del Usuario

Troubleshooting

WARNING
SERVICING.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors,
or dropped into water, take it to a service center prior to continuing use.
If a minor problem develops, it usually can be remedied quite easily when the cause is identified by using
the check list below.
Problem
Vacuum won't run
Vacuum suction low
Nozzle won't pick up
12
TO REDUCE THE RISK OF PERSONAL INJURY–UNPLUG BEFORE CLEANING OR
Possible Cause
1. Power cord not firmly
plugged in.
2. No voltage in wall plug.
3. Blown fuse or tripped
breaker.
4. Thermal Protector Activated
1. Bag full.
2. Obstruction in nozzle.
3. Secondary filter dirty.
1. Nozzle brush worn.
Possible Solution
1. Plug unit in firmly.
2. Check fuse or breaker in building.
2. Replace fuse/reset breaker in building.
3. Allow cleaner to cool per instructions on
page 5.
1. Empty bag.
2. Remove obstruction.
3. Clean filter.
1. Replace brush