Klarfit Husky Vario Manual De Instrucciones página 17

Attaching the handle
Attach the two support tubes to the frame on the rear side. Align the holes
on the support tube with the open end of the mounting tube. Screw the
screws through the tube and the holes. Secure the screws with nuts from
the inside of the cabin. Tighten the screws and nuts with a screwdriver and a
wrench. Slide the ends of the handlebars into the mounting tubes, align the
holes, insert and lock the locking pins.
Adjusting the handle
Press the buttons on each side and turn the handlebars to a comfortable
position. Push the handlebar up or down to make sure it is locked in place.
EN
17