Lista CSE450 Traducción De Las Instrucciones Originales página 26

OPERATION
INTRODUCTION
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED uSE
The product is intended for cutting and trimming
hedges and bushes in domestic use.
1.ASSEMbLy OF THE GuARD (See Fig. A)
Insert the guard into the slot as illustrated in Fig
A, and use two screws to fix the guard securely.
WARNING: Do not use the product without
fitting the guard.
A
2. MAINS SuPPLy CAbLE STRAIN RELIEF
(See Fig. b)
For strain relief of the cable, form a loop of the
end of the extension cable and bring this through
the opening at the handle and suspend in the
A
tension relief at the handle.
B
B
C
3. STARTING AND STOPPING (See Fig. C, D)
bEFORE STARTING yOuR HEDGE TRIMMER
Press both sides of the front end of Blade Sheath
(5) as shown in Fig C, and then remove the
blade sheath.
TO START yOuR HEDGE TRIMMER
There are two switch levers fitted in your Hedge
C
D
trimmer (2&3).
Both switch levers need to be depressed for
the product to start. Depress and hold the front
switch lever (3) and press the switch lever (2).
TO STOP yOuR HEDGE TRIMMER
Move Hedge trimmer away from cutting area
before stopping.
D
26
E
A
To stop, release one of the switch levers.
WARNING: If any parts are missing,
damaged or broken, do not operate your
Hedge trimmer until all damaged parts have
been replaced or repaired. Failure to do so could
result in serious personal injury. B
C
D
4. HOW TO uSE yOuR HEDGE TRIMMER
Inspect the area to be cut before each use,
remove objects which can be thrown or become
entangled in the cutting blades.
Always hold the Hedge trimmer with both hands
and with the blade away from you before turning
E
it on.
Always keep the power cord behind the
Hedge trimmer when in use. Do not place it
over the hedge that you are trimming where it
may be cut by the blade.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade.
F
Allow the cutting blades to reach full speed
before entering the material to be cut.
Always work going away from people and solid
objects such as walls, large stones, trees,
vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer. Disconnect the Hedge trimmer from
the mains and clear the jammed debris from the
cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Move the Hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to feed
into the cutting blade.