Operating Instructions
VACATION
For short vacation periods, leave the unit at its regular setting. During longer absences:
1. Remove all foods.
2. Disconnect the power cord from the electrical outlet.
3. Defrost and clean the freezer thoroughly.
4. Leave the lid open to avoid possible formations of condensation, mold or odors.
MOVING
Remove or securely fasten down all loose items inside the unit. To avoid damaging the levelling legs,
turn them all the way into the base.
If it is necessary to transport the unit on its back or side, ensure that the unit is allowed to remain up-
right and undisturbed for a minimum of 4 hours to allow the coolant to settle.
Troubleshooting
PROBLEM
Does not work •
•
•
Freezer runs
•
continuously
•
•
•
•
Internal tem-
•
perature not
•
cold enough
•
•
•
•
•
•
•
POSSIBLE CAUSE
No power to unit
Power cord is unplugged
Wrong voltage is being used
Temperature set too low (too
cold)
Lid is not closed
Hot food was inserted
Lid opened too long or too often
Close proximity to heat source
or direct sunlight
No power to unit
Power cord is unplugged
Temperature set too high
Lid is not closed
Hot food was inserted
Lid opened too long or too often
Air fl ow obstruction
Wrong voltage is being used.
Close proximity to heat source
or direct sunlight
Tel: 1-800-26-DANBY (1-800-263-2629)
•
Check connection of power cord to power
source
•
Plug in unit
•
Use proper voltage
•
Set temperature control to warmer setting
•
Close lid securely
•
Be sure food is at room temperature be-
fore inserting
•
Minimize lid openings / duration
•
Do not place unit close to heat sources or
direct sunlight
•
Check connection of power cord to power
source
•
Plug in unit
•
Check setting and increase as needed
•
Close lid securely
•
Be sure that food is at room temperature
•
Minimize lid openings / duration
•
Allow room for air to circulate around unit
•
Use proper voltage
•
Do not place unit close to heat sources or
direct sunlight
5
SOLUTION