ELECTRODRIVE CDC Manual Del Operador página 11

5 - Escape from programming mode
During step 3 you can return to parameter
selection without saving the adjustment made:
push P1 with the joystick in neutral position
(see the illustration).
L1 and L2 flash synchronously (slowly).
Push P4 and P5 at the same time to exit without saving or
selecting another parameter (step 2).
Restore factory setting
After enabling programming mode (step 1):
Push P2 and P3 at the same time with the
joystick in neutral position (see the illustration).
L1 and L2 flash not synchronously.
Push P4 and P5 at the same time to
save factory setting (see the illustration).
L1 and L2 turn off.
Switch off the system.
Switch on the system again (see the illustration).
Leds L1 and L2 flash twice slowly.
Only at this moment the factory setting become effective.
Factory setting
selection
Saving
Switch off -
Switch on
- 9 -
P1
P2
P3
P5 P4
On/off
butto