ELECTRODRIVE CDC Manual Del Operador página 9

1 - Enable programming mode
Push together P4 and P5 for 3 seconds (see the illustration).
"Programming mode" is enabled.
Leds L1 and L2 start flashing synchronously.
Proceed to step 2
2a - Minimum Current selection
Select the output by moving the joystick
in the related direction and push P3
(see the illustration).
L1 keeps flashing.
L2 flashes according to the actual parameter
value
Proceed directly to step 3
2b - Maximum Current selection
Select the output by moving the joystick
in the related direction and push P2
(see the illustration).
L1 keeps flashing.
L2 flashes according to the actual parameter
value
Proceed directly to step 3
2c - Reduced speed current selection
Select the output by moving the joystick
in the related direction and push P1
(see the illustration).
Note. Before going into programming
mode for reduced speed, the function shall
be activated (L1 is lightning). This makes it
possible to test modified setting while
being in programming mode.
L1 keeps flashing.
L2 flashes according to the actual
parameter value.
Proceed directly to step 3
P3
Maximum current selection
for output "\arm lowering".
P1
- 7 -
L2
P5 P4
Minimum current selection
for output "arm lowering".
P2
P1
Reduced speed current
selection
for output "arm lowering".
L1