Getting Started; Delay Timer - Rio CWAX3 Manual Del Usuario

Connect the power cord to the unit and plug into the mains supply.
STEP 1
1
Press the Start button and the unit will start heating. The heater will rapidly rise to the 90°C pre-set temperature.
STEP 2
Stir every 10 minutes until the wax is at the desired consistency for use.
STEP 3
Depending on the amount of wax being heated it will take between 30 and 60 minutes to heat the wax to
approximately 90°C. The wax temperature will then be maintained.
A D J U S TI N G T HE H EA T ER T E M P ER AT U RE
Some waxes specify a specific temperature for use. The heater temperature can be adjusted using the UP and DOWN buttons before
pressing the start button.
STEP 1
Press the Delay Timer button.
STEP 2
Use the UP and DOWN buttons to adjust the delay timer
to between 0.5 hours and 24 hours.
NOTE: To reset the temperature or delay timer while the unit is in use, p ress Start/Stop to deactivate the current setting, then use the UP and
DOWN buttons to adjust as above.
6
G ET T I NG ST A RT E D

DELAY TIMER

STEP 3
Press the Start/Stop button to set the time delay.