User Maintenance - Andis CI-41 Instrucciones De Uso Y Cuidado

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

TEMPERATURE SETTINGS

The styling temperature will depend

on your hair's texture and condition.

Generally, for fine, bleached or hair in poor

condition, use lower settings. For normal

hair, use higher settings Once your curling

iron reaches the temperature you select, it

maintains it all through styling.

CAUTION: Care should be used when

using this appliance on damaged or color

treated hair.

CURLING TIPS

SIZE OF CURL: Depends on the amount of hair you curl at one time.

The larger the section, the looser the curl.

DIRECTION OF THE CURL: Depends on the way you wind the hair around

the barrel. To turn hair up, place clamp under the section, with barrel on

top, and wind hair upwards. For a turned-under look, place clamp over the

section, with barrel underneath, and wind hair under.

AMOUNT OF CURL: Depends on how long you hold the appliance in

position after winding the hair. For example, to create a very firm curl, hold

in place for approximately 30 seconds. When a straight look is desired, keep

your appliance moving slowly down the hair section.

TO USE YOUR ANDIS CURLING IRON

1. To pre-heat your Andis curling iron, plug into an electrical outlet. Push

the "ON" button and turn temperature dial to desired setting. When the

unit is first turned on, the red light will blink. When the iron reaches the

selected temperature, the red light will stop blinking. Be sure to turn the

iron off by pushing the "OFF" button when you are done.

2. Always make certain that your hair is completely dry before styling with

your curling iron. Part off a section of hair to be curled. Comb through

this section to smooth out any snarls. Hold ends taught with one hand.

3. Open clamp and grip hair within one inch of scalp. If desired, hold in

place for about 10 seconds to create extra volume for your finished style.

Then slide iron through hair until ends extend slightly beyond barrel.

4. Roll iron in the desired direction, with ends following the direction of the

curl, and wind one or two revolutions. For a full curl, wind to within

one-half inch of scalp. Hold iron in place 20-30 seconds.

5. Release curl by gently pressing and releasing clamp in a scissors-like

motion. Then, gently withdraw the iron. For added support, secure curls

with clips and spray lightly with a good quality hair spray. Always allow

curls to cool completely before brushing or combing them.

Temperature

Setting

Red

Light

Temperature

Dial