Publicidad
TEMPERATURE SETTINGS
The styling temperature will depend on your hair's texture and condition. Generally,
for fine, bleached or hair in poor condition, use lower settings. For normal hair, use
higher settings. Once your curling wand reaches the temperature you select, it
maintains it all through styling. CAUTION: Care should be used when using this
appliance on damaged or color treated hair.
Wand
Stand
CURLING TIPS
For tighter curls, use the narrower section of the barrel; for looser curls, use the wider
section. The amount of curl will depend on how long you keep hair wrapped around
the wand and the amount of hair you curl at one time. The longer you keep hair
wrapped, the tighter the curl. The more hair you curl at one time, the looser the curl.
TO USE YOUR ANDIS CONICAL CURLING WAND
1. To pre-heat your Andis curling wand, plug into an electrical outlet. Push the ON
button and turn temperature dial to desired setting. When the unit is first turned
on, the red light will blink. When the wand reaches the selected temperature, the
red light will stop blinking.
2. Always make certain that your hair is completely dry before styling with your curling
wand. Part off a section of hair to be curled. Comb through section to smooth out
any snarls. Hold ends taught with one hand.
3. Take sectioned hair and wrap around wand; wrap the ends last. Keep hair wrapped
around wand by holding the very ends with your fingertips. Be careful not to get
fingertips too close to hot wand.
4. Gently unwrap hair and withdraw the wand. For added support, secure curls with
clips and spray lightly with a good quality hair spray. Always allow curls to cool
completely before brushing or combing them.
5. Be sure to turn the wand off by pushing the "OFF" button when you are done.
USER MAINTENANCE
This appliance does not require special maintenance, cleaning or lubrication. Keep
surfaces free of dust, dirt, and hair products. If cleaning is necessary, unplug wand and
wipe with a damp cloth. If wand does not get hot, return for servicing. Service only
through Andis authorized service stations. To find an Andis authorized service
station near you log on to www.andis.com or contact our customer service
department: 1-800-558-9441 (U.S.) or 1-800-335-4093 (Canada).
Untwist cord before use. After use, allow unit to cool, re-wrap cord and store in a safe
place. Do not wrap cord around appliance. Do not hang the unit by the power cord.
4
Temperature
On/Off Buttons
Control Indicator
Temperature
Power
Swivel Cord
Control Dial
Indicator Light
E S P A Ñ O L
Sírvase leer las instrucciones siguientes antes de usar su nuevo artefacto
Andis. Si brinda el cuidado que merece este instrumento fino construido con
precisión, obtendrá muchos años de servicio.
PRECAUCIONES IMPORTANTES
Cuando use cualquier aparato eléctrico, especialmente en
presencia de niños, siempre cumpla con las precauciones
básicas de seguridad, incluyendo las siguientes: LEA
TODAS LAS INSTRUCCIONES ANTES DE USAR ESTE
APARATO. NO LO ACERQUE AL AGUA.
PELIGRO:
Como es el caso con todos los
aparatos eléctricos, las piezas eléctricas tienen corriente
incluso cuando el interruptor de encendido está en la
posición de apagado. Para reducir el peligro de muerte
por descargas eléctricas:
1. Siempre desconecte el aparato inmediatamente al
terminar de usarlo.
2. No use el aparato mientras se esté bañando.
3. No coloque ni guarde el aparato donde éste pueda
caer dentro de una bañera o un lavamanos.
4. No ponga el aparato ni lo deje caer en agua ni en
ningún otro líquido.
5. Si algún aparato eléctrico llegara a caer en agua,
desconéctelo de inmediato. ¡No meta la mano al agua
para tratar de sacarlo!
ADVERTENCIA:
sufrir quemaduras, electrocución, o lesiones, o para
evitar un incendio:
1. No deje aparatos eléctricos desatendidos cuando
estén conectados.
2. Es necesaria una supervisión muy de cerca cuando
este artefacto sea usado por, en o cerca de niños o
personas con ciertas discapacidades.
Para reducir el riesgo de
5
Publicidad
