The Sharper Image EVSI-HD30 Manual De Instrucciones E Información De Garantía página 6

How to Fill
CAUTION: Before filling unit with water, turn power off and unplug unit from the outlet.
Note: Always use two hands to carry the water tanks.
1. Grasp tank handles with both hands and lift
2. Turn the tank upside down—remove the tank
3. fill the water tank with clean, cool water. We
4. Replace the tank cap by turning clockwise
5. Install both tanks back on the base of the unit.
up from humidifier base. Remove only one
tank at a time.
cap by turning it counter-clockwise.
recommend using distilled water if you
live in a hard water area.
until tight.
Make sure the tanks are firmly seated.
Note: This unit uses water from one tank at a
time. It will use all the water from one tank
before beginning to pull water from the
other tank.
10
About White Dust:
Use of high mineral content hard water may cause a white mineral residue to
accumulate on surfaces in the room near the humidifier. The mineral residue is
commonly called "white dust." The higher the mineral content (or, the harder your
water is), the greater the potential for white dust. The white dust is not caused by
a defect in the humidifier. It is caused only by minerals suspended in the water.
How and Why To Use Demineralization Cartridges:
The Sharper Image demineralization cartridge will help reduce the potential
for white dust, a deposit of minerals left behind from using hard water in your
humidifier. The cartridge should be replaced every 30 – 40 fillings. The cartridge
may need to be replaced more often if you are using very hard water. Replace
the cartridge when you notice an increase in white dust build-up. If white dust still
forms around the humidifier after a new cartridge has been installed, consider
using distilled water. To purchase new demineralization cartridges, model # EV-
HDDC4-6CTM, go back to the retailer (where you purchased your humidifier), or
visit www.sharperimageparts.com
If you live in an area with hard water, or use a water softener,
we recommend using distilled water for better results from your
humidifier. Never use water softening additives in your humidifier.
Installing Instructions:
1. Remove demineralization cartridge from packaging and let it soak in water for 10
minutes.
2. Remove the tank from humidifier base and turn it over.
3. Unscrew the tank cap by turning the cap counter-clockwise.
4. fill the tank with water as shown in the How To Fill Section.
5. Add the soaked demineralization cartridge into the tank.
6. Replace the tank cap by turning clockwise.
7. Place the tank back on the base.
1 1