Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
LAND ROVER
Range Rover 95-02
Maxium Crossbar Spread
Locate black panels in trim. There are three pairs
of these on the roof.
*See note 114 on the last page.
1031347F - 1/4
M1
M1
M2
M2
39"
39"
39"
10"
Attach clip to towers.
Refer to Q-tower
instruction to
attach clips.
Make sure clip is
properly engaged as
shown.
88
VINYL
LINERS:
Line the
M3
M3
M4
M4
underside of
the clip
38
30"
"
bottoms with
the black vinyl
stickers.
38"
57"
Push down and slide panel in trim completely open
to expose mounting points.
Position towers over
openings as shown.
REFER TO THE Q-TOWER INSTRUCTION
FOR PROPER TIGHTENING, CAUTIONS,
AND REQUIRED SAFETY CHECKS.
B
Q88
IMPORTANT!
Part # 1031347 RevF
Publicidad
Manuales relacionados para Yakima Q88
Resumen de contenidos para Yakima Q88
- Página 1 VINYL LINERS: Line the LAND ROVER underside of the clip Range Rover 95-02 39” 39” 30” " bottoms with the black vinyl stickers. 39” 10” 38” 57” Maxium Crossbar Spread Locate black panels in trim. There are three pairs Push down and slide panel in trim completely open of these on the roof.
- Página 2 GARNITURES DE VINYLE Coller les garnitures LAND ROVER noires en vinyle aux Range Rover 95-02 39” 39” 30” 99cm 96,5cm 76cm " crochets, sur la face Distance maxi entre intérieure, 99cm 96,5cm 145cm barres transversales 39” 10” 38” 57” Maxium Crossbar Spread en bas.
- Página 3 RECUBRIMIENTOS DE VINILO: LAND ROVER Forre la parte inferior de la base del clip Range Rover 95-02 39” 39” 30” 99cm 96,5cm 76cm " con los recubrimientos Máxima separación 99cm 96,5cm 145cm de vinilo negros. 39” 10” 38” 57” Maxium Crossbar Spread entre travesaños Empuje hacia abajo y deslice el panel en el listón Ubique los paneles negros en los listones del...
- Página 4 Caution! Check clips after Clips are installed in pockets on rooftop trim strip. installing. Grab each clip and try to pull them away from your Les crochets se posent dans les logements ménagés vehicle. Pull hard! If the clip sous la garniture de toit. moves tighten the adjustment post.