Charging Process; Autostart - Gewiss GWJ3001A Manual De Uso E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83
JOINON WALLBOX I-CON BASIC recharging unit for electric vehicles
10.
0
1
2
48

CHARGING PROCESS

The steps needed to carry out a recharging session are indicated below (but they may vary according to the
operating mode).

10.1. AUTOSTART

The recharging station is always accessible and ready to begin a charging session as soon as a vehicle is con-
nected.
It's fitted with a selector for choosing the recharging power.
POSITION 0
0
0
1
1
2
RECHARGING AT 100% OF
NOMINAL POWER
NOTE= For AUTOSTART models with a nominal power of 4.6kW, charging at 30% is forced on a 6A current value
to avoid any possible problems when the charging operation begins.
Some electric car models may have a minimum charge power limit.
To ensure that the minimum charge power selector on the I-CON AUTOSTART station is used correctly, please check this value in
your car instruction manual.
For example, the minimum power limit for the Renault Zoe® is about 1.8kW (8A) for a single-phase recharge and 8.5kW (13A)
for three-phase, so in the case of a 4.6kW I-CON AUTOSTART charging station, the selector will have to be set at 100% or 60%.
A 30% selector setting is lower than the minimum power permitted by the car, so the recharging session will not be started.
To enable a recharging session:
#
Action to be carried out
1
Make sure there are no errors on the charging station
Use the selector on the side to decide the
2
charging power you want to use.
Insert the charging plug in the socket-outlet of the station,
and in the vehicle
3
or
Connect the mobile connector to the vehicle.
Once the CP and PP signals have been checked, the recharg-
4
ing station will mechanically block the plug in the socket-outlet.
The recharging session begins
5
The vehicle requests energy from the recharging station
6
Recharging session in progress
POSITION 1
0
0
0
1
1
1
2
2
2
RECHARGING AT 60% OF
NOMINAL POWER
POSITION 2
0
0
1
1
2
2
RECHARGING AT 30% OF
NOMINAL POWER
RGB LED status
Fixed green
Fixed green
Fixed green
Flashing blue
Fixed blue
Fixed blue or flashing blue
0
1
2
2

Publicidad

Tabla de contenido
loading

Tabla de contenido