bebeduE SLAAP Manual Del Usuario página 15

"IMPORTANT: PLEASE READ ThE-
SE INSTRUCTIONS FOR USE CARE-
FULLY AND SAVE ThEM FOR FU-
TURE REFERENCE".
Foldable cribs are designed to be used only when the anchoring mechanisms of
the folding systems are correctly adjusted.
hOW TO ASSEMBLE ThE CRIB
· Remove the crib from its transport bag. Unbuckle the three attachment Velcro
strips that are included in the base/mattress and pull-out the body of the crib
(Fig. 1).
· Place the body of the crib in such a way that the legs on the bottom part are
supported on thefloor and at a distance of 50 cm from one to the other (Fig. 2).
· Life the short sides until you hear a "click". Then lift the longer sides. It is impor
tant to maintain the base untensed so that the sides can be stabilized (Fig. 3).
· Tighten the base by pressing on it from the center downwards (Fig. 4).
· Attach the fabric in the corners with the Velcro strips.
· Check that all sides are blocked prior to putting the mattress in place. Extend
the base/mattress along the bottom in such a way that it is completely flat and
with the strips on its inferior part.
"WARNING: if a mattress that is not supplied by the manufacturer is
to be used, then its thickness must be such that it does not surpass the
white line that is marked on one of the crib's sides".
hOW TO INSTALL ThE BASSINET KIT
First check operation of the article before using it with the baby.
The Bassinet kit allows elevating the mattress to the height of the parents' bed, in
such a way that the baby is always in your reach.
Note: remove the mattress from the crib prior to installation.
· Extend the fabric of the Bassinet kit over the crib, in such a way that the corners
coincide.
· Place the four hooks over each long side of the crib and two over each short
side, then attach the corner Velcro strips to correctly adapt the Bassinet (Fig. 5).
· Assemble the two tubes and place them over the base of the Bassinet, then atta
ching them with the Velcro strips (Fig. 6).
· Place the mattress over the base of the Bassinet kit and make sure that it is com
pletely flat. To fix the mattress securely, put the three velcro strips found on
both sides of the mattress into the holes in the bassinette and secure them (Fig. 7).
UK
15