Troubleshooting; Troubleshooting Guide - Anderson VERSA-CRIMP BP18CC129ACSR Instrucciones De Seguridad, Funcionamiento Y Mantenimiento

10

TROUBLESHOOTING

It is not recommended that the end user attempt to perform repairs on this tool, as specialized tools, training, and/or
procedures may be required.
Should you have any problems or questions with your HUBBELL ANDERSON
hesitate to contact the HUBBELL ANDERSON
at 1-800-426-8720.

TROUBLESHOOTING GUIDE

SYMPTOM/PROBLEM
Ram does not advance
when activation trigger is
pressed.
Ram does not fully extend.
Excessive or unusual noise
from tool.
Oil leaks from tool.
Number of cuts per charge
decreases with each battery
recharge.
Tool will not stop running
after activation trigger is
released.
For further assistance, contact the HUBBELL ANDERSON
ANDERSON
Tool Service Center for tool servicing and repair related questions
®
CAUSE
- Battery is not charged.
- Ram release lever/valve is being
held open.
- Pump is damaged.
- Activation trigger switch failure.
- Hydraulic system failure.
- Mechanical vibrations.
- Cavitation due to cold hydraulic
fluid.
- Cavitation due to hot hydraulic
fluid.
- Seal defect or mechanical
problems.
- Battery is too warm due to
frequent discharge/recharge
cycling.
- Activation trigger stuck.
- Switch failure.
Products
®
hydraulic tooling, please do not
®
- Charge the battery according to the
battery charger instruction
manual provided with your tool.
- Press and release the ram release
lever to reset the valve.
- Return to factory for repair.
- Return to factory for repair.
- Return to factory for repair.
- Return to factory for repair.
- Allow tool to warm up before use.
- Allow tool to cool before continuing
use.
- Return to factory for repair.
- Allow battery to cool to room
temperature before recharging.
- Alternate batteries often.
- Check for contaminants around the
trigger switch area.
- Remove battery and return to
factory for repair.
Tool Service Center at 1-800-426-8720.
®
REMEDY