Specifications - Hydraulic Power Source; Pre-Operation - Anderson VERSA-CRIMP BP18CC129ACSR Instrucciones De Seguridad, Funcionamiento Y Mantenimiento

SPECIFICATIONS - HYDRAULIC
POWER SOURCE
The internal hydraulic power source achieves high
pressure during normal operation. Do NOT disassemble
this tool at any time. Disassembly of this tool may result
in severe personal injury or tool damage, and will void the
warranty.
The hydraulic power system is located internally within the
tool and is a non-field serviceable item. If you suspect that
your tool is not functioning properly, please contact the
HUBBELL ANDERSON
®
1-800-426-8720.
PRE-OPERATION INSTRUCTIONS
Read and follow all PRE-OPERATION and safety
instructions provided for your
the battery charger (see Charger Instruction Manual)
and accessories. Failure to follow the proper operating
instructions and safety information provided can lead to
serious personal injury or death.
Blades must be cleaned and inspected for fine cracks or
damage before each use. Blades with cracks or damage
may break during frequent use or when subjected to high
cutting pressures. Replace damaged blades immediately
to avoid serious personal injury.
1) Clean blades of dirt and oils with a dry, clean cloth.
2) Carefully inspect each blade for fine cracks. A stress
crack will normally develop after extended use around
the lower portion of the blade's "U" shape and extend
downwards.
3) Immediately replace any blade exhibiting the possible
formation of a stress crack.
4) Visually inspect the blade for nicks or notches. Use a
sharpening stone to smooth minor flaws of the cutting
blade to enhance the cutting action.
5) Replace blades that have damaged cutting surfaces
to improve the cutting operation and to reduce blade
and tool stress.
ANDERSON
Tool Service Center at:
BP18CC129ACSR
Products
®
Before operating your BP18CC129ACSR, carefully read
and follow these PRE-OPERATION instructions to ensure
your tool is in proper working condition. Read and follow the
Battery Charger Instruction Manual included for operating
your battery charger unit. Following these instructions,
charge the battery(s).
1. With a fully charged battery installed, depress the
upper trigger first to make certain that the tool ram is fully
retracted.
NOTE: To maximize the crimp cycles available from a
battery, ensure the battery is fully charged before operating.
Before proceeding to step 2 make certain that the latch
is closed.
2. Insert a charged battery into the tool handle. The battery
will only insert in the proper orientation. The battery will
snap into place securing the battery to the tool.
Please note that it is not necessary to have a battery
installed in the
tool ram.
and for
BP18CC129ACSR in order to retract the
7