CARE FITNESS MED 2040 AeroMagnetic Manual Del Usuario página 24

HEART RATE TARGET ZONES
Press the left hand key until 'SPEED' is displayed then hold the right hand key for 3 seconds. The TIME will be
flashing; press the left hand key to select the heart rate target zone settings.
Press the right hand key to increase maximum heart rate limit. After setting the maximum heart rate, press the left
hand key to adjust the minimum heart rate limit.
PERSONAL DATA SETTING
1. GENDER: Press the left hand key until SPEED is displayed then, press the right hand key for 3 seconds. The TIME
will be flashing, press the left hand key until the gender icon is blinking. Press the right hand key to select the gender.
2. Press the left hand key to set the measuring value for weight (Lb or Kg), press the right hand key to select.
3. BODYWEIGHT: Press the left hand key to set the bodyweight, press the right hand key to increase the weight.
Press and hold the right hand key for rapid advance.
TROUBLESHOOTING
No Display on Console
1. Hold down any key to bring the console to "Quick Start" mode.
2. Ensure that the batteries are installed properly in the console and transmitter. If they are, install fresh batteries.
No Heart Rate signal displayed
1. Ensure that your chest strap is worn correctly and that there is moisture under the electrodes.
2. Relocate the bike away from any equipment that could potentially interrupt the radio frequency signal, such as a
DVD player or television, etc.
Cadence number jumps high or low
1. Separate bikes that may be set to the same console code and are cross-talking, or re-synchronize the transmitter
and console.
2. Relocate the bike to a different part of the room, away from any radio frequence interference areas.
Heart Rate signal gets interrupted or drops out
1. Ensure that there is a minimum distance of 36 inches/ 90 cm between bikes.
2. Verify that your chest strap is secure and that the electrodes are making contact with your chest at all times.