Maintenance Instructions - Pelonis FS40-8M El Manual Del Propietario

2. Clutch knob
Press down on clutch knob to oscillate the fan. To stop
oscillation, pull up on the clutch knob once the fan is in the
desired position.
3. Tilt adjusting
To adjust the air flow upward or downward, slightly push
the guards.
4. Height adjusting
From the external pole loosen the height adjustment ring and
adjust the internal pole to the desired height. (See Fig.3)

MAINTENANCE INSTRUCTIONS

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Do not leave the unit plugged in while cleaning or assembling.
2. To ensure adequate air circulation to the motor. Keep vents at the rear of the
motor housing from dust, fluff and etc. A vacuum cleaner can not be used to
clean these vents before unplugging. Do not disassemble the fan to remove fluff.
3. Please wipe the exterior parts with a soft cloth soaked in a mild detergent.
Do not use any abrasive detergent or solvents to avoid scratching the surface.
Do not use of the following as a cleaner: gasoline, thinner, bending.
4. Do not allow water or any other liquid into the motor housing or interior parts.
USER SERVICING INSTRUCTIONS
1. Grasp plug and remove from the receptacle or other
outlet device. Do not unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of
attachment plug towards blades.
3. Remove fuse carefully.Push the fuse from the other side
or turn fuseholder over to remove fuse.
4. Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
6. Risk of fire. Do not replace attachment plug. It contains safety device (fuse) that
should not be removed. Discard product if the attachment plug is damaged.
Notice:
1. When you replace fuse, please don't operate suddenly or overexert, or else the
product will be damage or cause accident.
2. When you feel it hard to be operated, please make sure you have got the right way.
CLEANING
1. Be sure to unplug the power cord from the outlet before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge.
Thoroughly remove soap film with clean water.
3. Be sure not to get water or other liquid enter the inside of the motor.
3
3
2
1
0