ATORN 33172111 Modo De Empleo página 12

7. Switching off
E
The dial gauge goes automatically into stand-by if not used for 20 minutes, unless Auto OFF mode has been turned off
(see Chap. 4, advanced functions)
123. 4 56
mm
SET
Stand-by mode can be forced by a prolonged press (> 2 sec) on :
MODE
>2s
In stand-by mode, the value of the origin is retained by the sensor (SIS mode), and the instrument automatically restarts
with any movement of the measurement probe.
The instrument can be switched off completely for a long period of non-use, but this will necessitate a zero reset on restart
(the origin will be lost):
mm 123. 4 56
OFF
SET
- Prolonged press (>4 sec) on :
MODE
>4s
8. Re-initialising the instrument
The initial instrument settings can be restored at any time by a prolonged press (>4 sec) simultaneously on and
SET MODE
until the message CLEAr is displayed.
Nevertheless the instrument retains its confi guration settings (units and resolution) as well as the last active reference.
12