Work Pro W MD 82 AX MKII Manual De Instrucciones página 2

GRAPHICAL SYMBOLS EXPLANATION
This symbol, wherever used, alerts you to the
presence of un-isulated and dangerous voltages
within the product enclosure. These are voltages
that may be sufficient to constitute the risk of electric
shock.
This symbol, wherever used, alerts you to
important operating and maintenance
instructions. Please read.
Protective Ground Terminal
AC mains (Alternating Current)
Hazardous Live Terminal ON:
Denotes the product is turned on.
OFF: Denotes the product is turned off.
WARNING
Describes precautions that should be observed to prevent
the possibility of death or injury to the user.
CAUTION
Describes precautions that should be observed to prevent
damage to the product.
WARNING
Power Supply
Ensure that the mains source voltage (AC outlet) matches
the voltage rating of the product. Failure to do so could
result in damage to the product and possibly the user.
Unplug the product before electrical storms occur and
when unused for long periods of time to reduce the risk of
electric shock or fire.
External Connection
Always use proper ready-made insulated mains cabling
(power cord). Failure to do so could result in shock or
SAFETY RELATED SYMBOLS
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
TO RAIN OR HUMIDITY.DO NOT
REMOVE COVER. THIS PRODUCT IS
NOT INTENDED FOR USE OTHER THAN
STATED.
fire. If in doubt, seek advice from a registered
electrician.
Do not Remove Any Cover
Within the product are areas where high voltages may be
present. To reduce the risk of electric shock do not
remove any covers unless the AC mains power cord is
removed.
Covers should be removed by qualified service personnel
only.
No user serviceable parts inside.
Fuse
To prevent fire an damage to the product, use only the
recommended fuse type as indicated in this manual.
Do not short-circuit the fuse holder. Before replacing
fuse, make sure that the product is OFF and
disconnected from the AC outlet.
Protective Ground
Before turning the product ON, make sure that it is
connected to Ground. This is to prevent the risk of electric
shock.
Never cut internal or external Ground wires. Likewise,
never remove Ground wiring from the Protective Ground
Terminal.
Operating Conditions
Always install in accordance with the manufacturer´s
instructions.
To avoid the risk of electric shock and damage, do not
subject the product to any liquid/rain or moisture. Do not
use this product when in close proximity to water.
Do not install this product near any direct heat source. Do
not block areas of ventilation.
1