Cleaning Cooler And Pads; Removal Of The Back Panel - L.B.White PC-31 Instrucciones Y Manual Del Propietario

8
Evaporative Cooler

Cleaning Cooler and Pads

At regular intervals your evaporative cooler should be shut down and disconnected from power supply. The
water tank should be drained of dirty water and sprayed out with fresh water and refilled. The more you do
this the better it will work and less calcium will develop on pads or other surfaces. You may spray through
the cooling pads to wash them out and allow water to deposit in the tank to be drained away. The removable
panel and media pad can be sprayed out on the ground to clean pad. Use light pressure when spraying pads.
NEVER spray pads with water while cooler is operating and fan is running. This can cause damage to motor
and will void the warranty.

Removal of the Back Panel

(Disconnect power supply before this procedure.)
Unscrew the screws at top of back panel (3). Lift panel up and pull out at the bottom. Then slide panel out of
the cabinet. You will now have access to the pump, float valve and water distributor spreaders.
Owner's Manual • Evaporative Cooler