Checking The Digital Signal Strength; Labeling Channels; Labeling Video Inputs; Setting The Parental Control - Hitachi L40A105E Guia Del Propietario

Checking the digital signal
strength
This TV will allow you to view the digital signal meter for
digital channels.
1
Select "Channel ⇒ Signal Meter", then press ▶ or ENTER.
2
The digital signal strength screen will appear.
If necessary, adjust the direction of the antenna to obtain the
maximum signal strength.
CH
Signal Meter
0 50
Signal Level
NOTE:
• Signal meter feature is not available for analog channels.
• After 240 seconds the Signal Meter screen will clear and the TV
will return to normal viewing automatically.

Labeling channels

Channel label appears with the channel number display each
time you turn on the TV, select a channel, or press DISPLAY.
You can choose any four characters to identify a channel.
To create channel labels
1
Select "Channel ⇒ Channel Labels", then press ▶ or ENTER.
2
Press ◀ or ▶ to select a channel you want to label, then press ▼.
CH Channel Labels
Channel Number 15-1
Channel Label CH-1
Label Clear >>
3
Press ◀ or ▶ repeatedly until the character you want appears
in the first space.
CH
Channel Labels
Channel Number 15-1
Channel Label CH-1
Label Clear >>
The characters rotation as follows:
, () @ / + = -
-
SPACE
If the character which you desire appears, press ENTER.
Repeat this step to enter the rest of the characters.
If you would like a blank space in the label name, you must
choose the empty space from the list of characters.
4
Repeat steps 2-3 for other channel. You can assign a label to
each channel.
5
When you finish inputting the label name, press EXIT to return
to the normal screen.
100
To clear a Channel Label
After step 2 above, press ▲ or ▼ to select "Label Clear", then
press ▶ or ENTER.
NOTE:
• The channel labels will be reset after "Scan" on page 16.

Labeling video inputs

The Video Label feature allows you to label each input
source for your TV.
1
Select "Setup ⇒ Video Label", then press ▶ or ENTER.
2
Press ▲ or ▼ to select an input which you want to label.
3
Press ◀ or ▶ to select the desired label for that input source.
Video Label
Video1
Video2
Component
HDMI1
HDMI2
HDMI3
PC
Available video labels: – / VCR / DVD / STB / Cable / Satellite /
Receiver / Game / Camcorder / PC / DVI PC / Blu-ray

Setting the Parental Control

An age limitation can be set to restrict children from viewing
or hearing violent scenes or pictures that you may choose
to exclude. The restriction applies to "TV" and "Movie" if this
data is transmitted. You may set this restriction separately.
To use the Parental Control function, you must register a
password.
To register a password
1
Select "Locks", then press ▶ or ENTER.
2
Select and enter your password (4 digits) using Number
buttons (0-9), then press ENTER.
Locks
* * * _
New Password
" " appears instead of the number.
3
Enter the same password again to confirm, then press
ENTER.
The password is now registered.
NOTE:
• If you forget the password, contact Customer Service at
1-800-289-0981 (USA/Canada), 01-800-703-0885 (MEXICO)
for assistance.
Your original remote control will be required.
• To avoid forgetting the password, write it down and keep in a
safe place.
-
-
-
-
-
-
-
17 EN