Controls; Brightness/Contrast Controls; Auto Adjust - NEC MultiSync LCD2470WNX Manual Del Usuario

Controls

OSD (On-Screen Display) control buttons on the front of the monitor func-
®
tion as follows:
To access OSD menu, press any of the control buttons (MENU/EXIT, Left, Right,
Down, Up).
To change signal input, press the SELECT button.
NOTE: OSD must be closed in order to change signal input.
Button
MENU/EXIT
Left/Right
Down/Up
SELECT
RESET/DV MODE
NOTE: When RESET is pressed in the main and sub-menu, a warning win-
dow will appear allowing you to cancel the RESET function by pressing the
MENU/EXIT button.

Brightness/Contrast Controls

BRIGHTNESS
Adjusts the overall image and background screen brightness.
CONTRAST
Adjusts the image brightness in relation to the background.
AUTO Contrast (Analog input only)
Adjusts the image displayed to optimal settings.
DV MODE
Allows you to select the suitable setting for Movie, Picture, etc.

Auto Adjust

Automatically adjusts the Image Position, H. Size and Fine settings.
Image Controls
LEFT / RIGHT
Controls Horizontal Image Position within the display area of the LCD.
Menu
Exits the OSD controls.
Returns to the OSD main menu.
Moves the highlighted area left/right to select control menus.
Moves the bar left/right to increase or decrease the adjustment.
Direct adjust of brightness if HOT KEY is set to ON.
Enters the OSD menu if HOT KEY is set to OFF.
Moves the highlighted area down/up to select one of the controls.
Direct adjust of contrast if HOT KEY is set to ON.
Enters the OSD menu if HOT KEY is set to OFF.
Enter the OSD sub menu.
Activate the selected function.
Change the Input source.
Resets the highlighted control menu to the factory setting.
Enter the DV MODE.
Activates NTAA function when the OSD is not on-screen. Press
and hold for 3 seconds to activate.
(Analog input only)
(Analog input only)
10