Unit Assembly - Uline H-7028 Guia De Inicio Rapido

Carrito para resurtir 175.3 cm (69") de alto
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
Start with the bottom shelf. Snap the interlocking
pieces of a shelf support (wide end down) around
the post at the lowest groove where shelf is to be
located. Slide the support up or down until it snaps
into the groove. Add a shelf support to the same
height on the remaining posts. (See Figure 3)
Figure 3
2. Slide posts through underside of shelf until shelf
slides firmly over supports. (See Figure 4)
Figure 4
3. Stand unit upright. Gently tap shelf down to secure it
using rubber mallet. (See Figure 5)
Figure 5
PAGE 2 OF 6

UNIT ASSEMBLY

Shelf
Support
1-800-295-5510
uline.com
4. Place shelf supports on each post, 6" above the
bottom shelf to allow room for divider boxes. Slide
box guides onto posts on each side of shelving unit.
Gently tap box guides down to secure.
(See Figure 6)
5. Repeat this process with the remaining box guides
with 6" between each set of shelf supports.
6. Add shelf supports to very top of posts. Place top
shelf on shelf supports and gently tap with rubber
mallet. (See Figure 7)
Figure 7
Figure 6
0321 IH-7028

Publicidad

Tabla de contenido
loading

Tabla de contenido