Pentair Pentek* Solar Drive At A Glance - Pentair PENTEK PSD15 Manual De Instalación Y Funcionamiento

PENTAIR PENTEK SOLAR DRIVE AT A GLANCE
*
The Pentair Pentek Solar Drive PSD15 is an off-grid solar controller that can operate any approved
Pentair Pentek submersible motor loads or operate approved alternative 3-phase alternating
current (AC) motor loads up to 1.5HP from solar photovoltaic (PV) power.
To size the solar PV array to your specific motor, please
consult with your local dealer or Pentair. A typical
diagram for a Pentair Pentek Solar Drive operated solar
water pumping system is shown in Figure 1. The solar PV
array must be connected to an external DC Disconnect
and then to the Pentair Pentek Solar Drive controller.
The Pentair Pentek Solar Drive controller should be
installed in the shade (potentially mounted under the PV
array) and away from the direct sun.
The Pentair Pentek Solar Drive can accept up to two
digital sensor inputs. For example, in solar water
pumping applications, an optional float switch can be
connected to the Pentair Pentek Solar Drive to monitor
when a water tank is full, or a pressure switch can be
used in combination with a pressure tank.
Pentair Pentek Solar
Drive PSD15
PV Solar Array
Grid Power
Level
Switch
AC Motor
Pump
Water Tank
DC Disconnect
Figure 1: Solar Water Pumping System Diagram with
Pentair Pentek Solar Drive PSD15
4 P1061 (06/06/19)