Pentair Pentek Solar Drive Installation Requirements; Important - Pentair PENTEK PSD15 Manual De Instalación Y Funcionamiento

PENTAIR PENTEK
The Pentair Pentek Solar Drive must be installed in a shaded location, away from any source of heat and in
an area free of vegetation. Measures must also be made to protect the unit from damage by unauthorized
persons, large animals, overgrowth, flooding, or other harm.
The Pentair Pentek Solar Drive has voltages capable of causing severe injury or death by electrical
shock. It should only be installed and serviced by Pentair authorized suppliers, dealers and installers.
• Contact your Pentair Supplier/Dealer for any service or warranty claims
• NEC codes take precedence over suggestions in this manual
• We strongly recommend that the installation data be recorded into the "Installation Notes" section on
page 14 and that the manual is stored near the unit
The Pentair Pentek Solar Drive should be mounted at least 2 feet (60cm) above the ground when possible.
A minimum of 10 inches (25cm) of clearance above the Pentair Pentek Solar Drive is required for internal
access. There must be no obstruction of air flow to the heat sink. A typical installation on an array
structure is shown in Figure 3, below.
Once the Pentair Pentek Solar Drive is installed in a shaded location (see Figure 3), it can be wired to DC
(solar) sources. Maximum cable lengths for 115 and 230Vac for different motor load currents are shown in
Figure 2 below.
This unit was evaluated for temperature rating of 60/75°C (140/167˚F) on power field wiring terminals.
Motor
Load [A] Voltage [V]
3.5
4.5
5.5
7
IMPORTANT: Use copper conductors only!
Figure 2: Maximum Input Cable Lengths in Feet (based on 3% voltage drop)
Dimensions of the Pentair Pentek Solar Drive and back panel are shown in Figure 4, with additional details
on how to mount the unit on page 7.
Figure 3: Pentair Pentek Solar Drive Mounting
6
SOLAR DRIVE INSTALLATION REQUIREMENTS
*
Nominal
16
115 125
230 250
115 100
230 200
115 80
230 160
115 65
230 130
Solar PV Panel
10"
Solar PV Rack
24"
WARNING
AWG Copper Wire Sizes
90˚C (194˚F) insulation [ft]
14 12
180 300
360 600
150 250
300 500
125 200
250 400
95 150
190 300
4.25"
3"
Figure 4: Pentair Pentek Solar Drive Dimensions
10 8
450 700
900 1400
350 500
700 1000
300 450
600 900
230 350
460 700
5.5"
10"
P1061 (06/06/19)
4"