Product Maintenance - Fellowes Powershred 79Ci Manual De Instrucciones

Ocultar thumbs Ver también para Powershred 79Ci:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36052.
Remove Paper: When illuminated, press reverse (
SafeSense
Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
4
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
Turn off and unplug
Locate Auto-start
shredder
infrared sensor
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
ENGLISH
Model 79Ci
.
4
3
Dip cotton swab in
Using cotton swab, wipe
rubbing alcohol
away any contamination
from the paper sensors
the
®

Publicidad

Tabla de contenido
loading

Tabla de contenido