Important Safety Instructions; Important Safety Information - Fellowes Jupiter 125 Manual De Instrucciones

ENGLISH
Discrete carry
handles at side
Active Cooling System
CAPABILITIES
Pouch Thickness
Estimated Heat-Up Time
Approximate Cool-Down Time
Lamination Speed
Maximum Width
Voltage
Frequency
IMPORTANT SAFETY INSTRUCTIONS — Please Read Before Using!
• The socket-outlet must be installed near the equipment
and be easily accessible.
• To prevent electrical shock, do NOT use laminator close to water
and do NOT spill water on laminator, electric cord, or wall socket.
• Do not leave electric cord in contact with a warm surface.
• Do not leave electric cord hanging from a cupboard or shelf.
• Do not use laminator if electric cord is damaged.
• Do not laminate metal objects.

IMPORTANT SAFETY INFORMATION

This laminator is equipped with an Auto shut-off function. It will turn the laminator into
stand-by mode, if it has not been used for over 60 minutes. To switch the laminator
back on, simply press the stand-by button at the left of the front operating panel.
2
Opening lid to clean
laminating mechanism
Temperature controlled
release trigger for lid
3-7 mil
4 Minutes
60 Minutes
18"/Minute
12.5" mm
120V
60 Hz
LED Interface Key
Support Shelf on entry to
guide laminate path
Stand By
Laminating capacity – 3-7 mil hot laminating pouches
Up to 12.5"
1000 Watt
7 5
Dimensions: 21 / " x 9 / " x 4
8 8
1
Max document thickness / "
32
• Only use pouches specifically designed for the lamination setting you intend to use.
• Always supervise children during laminator operation.
• Keep pets away from laminator while in use.
• Switch off and unplug laminator when not in use.
• Only open the laminator as explained under "Maintenance". Do not open or
attempt to repair in any other way, as this could result in electric shock and will
void your warranty. C ontact Customer Service if you have questions. Please note
the warranty does not a pply in cases of abuse, mishandling or unauthorized repair.
• Please be careful of sharp edges and corners and residual heat when opening
the laminator.
During lamination, the direction of the pouch can be reversed, if you are unsure about
the progress of the lamination. To do so, press down the reverse key. This will eject
the pouch back at the front entry.
HeatGuard Technology™ double-walled
insulation keeps heat inside
LED Interface for
user guidance
LED Panel
Up
cold 3 4 5
Enter
3 4 5
7
Open
7 jam wait rev
Down Reverse
Left
3
/ "
4
Right