Plasticizing Of Blanks With Unknown Heating Times; Abort/Termination Of Programme - Dreve Drufosmart scan Instrucciones De Trabajo

Drufosmart scan
9.3 Calling of individual time programmes
Turn on the unit – the initial display will
be visible. By pushing the menu key
(j) several times you may select one
after another:
a) enter modus
b) F1
c) F2
d) F3
By pressing the menu keys (d/j) you may
navigate arbitrarily between the a. m.
programme points. Confirm the selected
programme point with the OK key (f).

9.4 Plasticizing of blanks with unknown heating times

Create an individual time programme
with high heating and cooling times
(see point 9.2). Start the programme
(see point 8.2). You may test the
plasticization degree of the blank by
means of an edgeless metal instrument
(e. g. wax knife).
Info
The complete deformability of the
blank can only be tested at the
edges, as that is where warmth
will leak through the metal con-

9.5 Abort/termination of programme

During an active time programme the
key pad is deactivated. It is possible
to abort/terminate all actions of the
38
Then go on as described in point 8.2.
tacts and the necessary flexibility
will be attained at last!
After the blank has attained the nec-
essary flexibility initiate the thermo-
forming process (see point 8.4). The
remaining heating time will be erased
from the display (a) and the adjusted
cooling time will be counted down (c).
The cooling time can be terminated at
any time by pulling the heating han-
dle (5).
Drufosmart scan by pulling the heat-
ing handle (5) as far as it will go (for
approx. 3 seconds).
9.6 Exceeding of entered heating/cooling times
After elapse of times adjusted regu- time will be blinking in the display as
larly (display position a/c) there will control mechanism.
be an acoustic signal. The exceeded
9.7 Entering a wrong barcode
If a barcode is scanned that does not By scanning the correct barcode you
correspond to the programming of the can proceed further, as described in
Drufosmart scan, four acoustic warning point 8.0.
signals will be heard and the display
will show ERROR at position b.
39