Bissell POWERGLIDE Guia Del Usuario página 10

Maintenance & Care
Cleaning the pre-motor filter
1. Unplug the cleaner from electrical outlet.
2. Remove the Easy Empty dirt container
from the vacuum base by pushing the tank
"empty" button.
3. Twist the top part of the dirt container
counter clockwise and lift to remove.
4. There are two pre motor filters: one foam filter
under a thinner fiber filter. If the filters appear
dirty remove both filters. Both pre motor filters
may be hand washed in cold water with mild
detergent. Rinse well and air dry thoroughly
before replacing the filters.
NOTE: The thinner fiber filter should be placed
on top of the foam filter.
5. Reassemble dirt container and place back
on vacuum.
NOTICE
Find Replacement Filters online at
www.BISSELL.com
Febreze™ Pre-Motor Filter - 1214
Pre-Motor Filter, Pre-Motor Fiber Filter,
Post-Motor Pleated Filter Pack - 12118
www.BISSELL.com
10
WARNING
Do not operate cleaner with damp or wet filters or without
vacuum bags and all filters in place.
2.
3.
4.
Tip
» Select models include a Febreze™ pre-motor filter
in addition to the foam pre-motor filter. Either
filter should be used along with the fiber filter.
This Febreze™ filter is compatible with all BISSELL
PowerGlide and PowerGlide Lift-Off vacuums.