PestWest Titan 300 Manual De Instrucciones página 2

TECHNICAL SPECIFICATIONS
MODEL
VOLTAGE
FREQUENCY
CONSUMPTION
GRID VOLTAGE
RATINGS
LAMP TYPE
DIMENSIONS
WEIGHT
MOUNTING
CONSTRUCTION
COVERAGE
PRECAUTIONS
ALL PESTWEST TRAPS ARE
FULLY INSULATED, CLASS I
APPLIANCES, NEVERTHELESS,
SENSIBLE PRECAUTIONS
SHOULD BE OBSERVED:
DANGER - HIGH
VOLTAGE!
SWITCH OFF THE
MACHINE BEFORE
SERVICING OR
CLEANING.
KEEP OUT OF REACH
OF CHILDREN.
FOR INDOOR USE ONLY
DO NOT USE IN LOCATIONS
WHERE FLAMMABLE VAPOUR
OR EXPLOSIVE DUST IS
LIKELY TO EXIST
MAINTENANCE MAY BE
CARRIED OUT BY PEOPLE
WITH REDUCED PHYSICAL,
SENSORY OR MENTAL
CAPABILITIES OR LACK OF
EXPERIENCE OR KNOWLEDGE
IF THEY HAVE BEEN GIVEN
THE SUPERVISION OR
INSTRUCTION.
NOT SUITABLE FOR USE IN
BARNS, STABLES AND
SIMILAR LOCATIONS
2
TITAN 300
220-240V
50-60Hz
50W / 0.45A
4000V (9mA)
IP20
15W PESTWEST QUANTUM® BL368nm T8 18" Shatter-Resistant - (PART NO. 130-000171)
H: 33CM W: 49.5CM D: 13.5CM
7.5KG
SUSPENDED / WALL MOUNTED / FREESTANDING
WHITE LACQUERED ZINTEC STEEL / 304 GRADE STAINLESS STEEL
180M
2
ENSURE THE UNIT IS
PROPERLEY EARTHED.
ENSURE THAT OPERATORS
HAVE AN ADEQUATE
AND SECURE WORKING
PLATFORM WHEN WORKING
ON THE MACHINES.
IF SUSPENDED, MOUNT AT
LEAST 2.5 METRES ABOVE
GROUND AND CLEAR OF ANY
TRAFFIC, SUCH AS FORKLIFT
TRUCKS.
TO MAINTAIN THE ATTRACTIVE
APPEARANCE OF THE UNITS,
WIPE DOWN AND CLEAN AS
OFTEN AS REQUIRED. USE
A CLOTH DAMPENED WITH
WATER AND DETERGENT OR
A PROPRIETARY CLEANER. DO
NOT USE SCOURING PADS OR
ABRASIVES.
DO NOT INSTALL IN DAMP OR
CORROSIVE ENVIRONMENTS.
Please read these instructions carefully and keep them
for future reference. Your PestWest fly killer has been
designed and constructed using top quality materials
and if installed correctly and kept clean, will operate
reliably and safely for many years. The Titan 300 unit may
be operated either wall-mounted or suspended.
SITING THE UNIT
Electric fly killers (EFKs) operate on the principle whereby
flying insects are attracted to light, particularly to the
ultra-violet (UV-A) range. However, the efficiency of
an EFK can be affected by the intensity of other light
sources, whether artificial or daylight. It is therefore
sensible to mount the EFK where competition from such
sources is minimised.
AS A GENERAL RULE:
• Wherever possible, mount the unit as ceiling
suspended then they will attract insects from all
directions.
• Do not mount adjacent to windows.
• The unit should be sited, wherever possible, at 90°
to the major light source, e.g.: the sunniest window.
• In food areas, mount the EFK close to, but not
directly over, exposed food or preparation surfaces.
• Mount units where they can be easily accessed for
servicing.
• Mount the unit above head height - in the case of
suspended mounting, clear of any traffic e.g. forklift
trucks.
• Avoid mounting your EFK in draughts.
• Site units near where flies are likely to gain access,
i.e.: doors opening to the outside, especially dustbin
areas.
• For maximum effectiveness, the EFK should be kept
switched on 24 hours a day.
For maximum effectiveness, the EFK should be kept
switched on 24 hours a day.
UNPACKING YOUR UNIT
Each unit is carefully inspected and packed before
leaving our factory. Before discarding the outer carton,
examine for obvious evidence of transport damage.
Pay particular attention to the removal of all packing
materials including the plastic transit packing on the
"Plug In" grid and any additional packing around the
fluorescent lamps.
To increase protection in transit, some models are
packed without the bottom catch tray fitted. This tray
should be attached to the unit, with the spring-catch on
the right as you look at the front of the unit.
INSTALLATION
All European versions are designed to operate from
220-240V 50-60 Hz. UK models, powered from 13
amp ring main systems, are supplied with a cord set,
terminated in a 13 amp plug, fitted witha 3 amp fuse.
Continental models are supplied with a cord set, terminated
with a schuco plug. Ensure the branch fuse is 16 amps
maximum.
Models destined for the US market are designed to
operate from 110-120v 60Hz input. The cord set is
terminated in a Nema 5-15 3-way plug. The units are
supplied with 2 metres of input cable as standard (8 ft on
some US models). If it is necessary to extend this lead, a
competent electrician must do this. Should a moulded-
on plug be removed from the lead supplied, this must