Sennheiser SKM 1072-U Instrucciones Para El Uso página 19

Microphone use
If the SKM 1072-U is used as a hand-held transmitter the sensitivity
should be switched to "
use the MZW 1032 windshield to reduce pop and wind noise.
If you want to wear the SKM 1072-U around your neck, use the supplied SZU
1032 lavalier clip as shown above. Set the sensitivity to "
Fault Finding
Fault
No function
Acoustic feedback
No transmission though
transmitter is switched on
Distortion
18
". For outdoor recordings and close-miking
LOW
Possible cause
flat or weak battery
battery inserted the wrong way round
microphone is too close to the loudspeaker(s)
receiver may not be equipped with
(The transmitter and receiver must both have the
same noise reduction system. Receivers with a
different noise reduction system will not only
sound incorrect but also increase susceptibility to
feedback. Make sure that the receiver is fitted
with
HiDyn
plus
receiver and transmitter are switched to
different frequencies
sensitivity too high, sensitivity switch should be
set to " " when the SKM 1072-U is used as
LOW
a hand-held microphone
HIGH
.)
®
".
HiDyn
®
plus