Hour Meter; Remove Contents From Carton; Assembly - Generac GP Serie Manual Del Propietário

120 VAC, 20 Amp Receptacle
The 120 Volt outlet is overload protected by a
20 Amp circuit breaker. See
receptacle will power 120 Volt AC, single
phase, 60 Hz electrical loads requiring up to
2400 watts (2.4 kW) or 20 Amps of current.
Use only high quality, well-insulated, 3-wire
grounded cord sets rated for 125 Volts at 20
Amps (or greater).
Figure 2-13. 120 VAC, 20 Amp Receptacle
NEMA 5-20

Hour Meter

The Hour Meter tracks hours of operation for
scheduled maintenance. See
• The CHG OIL display will illuminate every
100 hours. The message will flash one hour
before and one hour after each 100 hour
interval, providing a two hour window to
perform service.
• The SVC display will illuminate every 100
hours. The message will flash one hour
before and one hour after each 200 hour
interval providing a two hour window to per-
form service.
When the hour meter is in flash alert mode,
the maintenance message will alternate with
elapsed time in hours and tenths. The hours
will flash four times, then alternate with the
maintenance message four times until the
meter automatically resets.
• 100 hours - CHG OIL — Oil Change Inter-
val (Every 100 hrs)
• 200 hours - SVC — Service Air Filter
(Every 200 hrs)
NOTE: The hour glass icon will flash when the
engine is running. This signifies the meter is
recording hours of operation.
0000.0
Figure 2-14. Hour Meter
Owner's Manual for Portable Generator
Figure 2-13. This
004466
Figure 2-14.
000205

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
the following:
TABLE 3. Accessories
Item - All Models
Main Unit
Owner's Manual
Product Registration Card
Item - Models GP2800 and GP3300 Only
Wheel (A)
Axle (B)
Frame Foot (C)
Handle Assembly (D)
Hardware Bag
Handle Bracket (E)
Cotter Pin (F)
M8-1.25 Hex Flange Nut (G)
M8-1.25 x 40 Hex Head Bolt (H)
M8-1.25 x 45 Hex Head Bolt (J)
M8-1.25 x 55 Hex Head Bolt (K)
Washers (L)
3. Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) with the unit
model and serial number for any missing
carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.

Assembly

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) for any assem-
bly issues or concerns. Please have model
and serial number available.
The following tools are required to install the
accessory kit.
• Needle nose pliers
• Ratchet
• 12mm socket
• 12mm wrench
Qty.
1
1
3
2
2
2
1
Qty.
1
2
5
2
4
1
2
(000100a)
9