Install The Housing On The Pan-Tilt Motor - Axis Communications YP3040 Manual Del Usuario

Install the Housing on the Pan-Tilt Motor

1. Detach the adapter bracket by removing the mounting screws on the brace, using the
supplied allen key.
2. Use the supplied two countersunk screws to mount the housing on the adapter bracket.
3. Attach the adapter bracket with the housing to the brace.
Connect the Cables
1. Connect the power supply to the pan-tilt motor according to the Installation Guide
supplied with the mains adaptor. The recommended mains adaptor is AXIS PS24 Mains
Adaptor. For more information on this product, see the Axis web site at www.axis.com
Power supply cable 24 V AC
2. Connect the PTZ control cable to the camera's RS485 port. Different camera models have
different terminal connectors, be sure to follow the correct description for the installed
camera. The correct connector is supplied with the Axis network camera. For more
information on Axis network cameras, see the Axis web site at www.axis.com
PTZ control cable (RS485)
3. Connect the camera to the network, see the Installation Guide provided with the camera.
Note
The RJ45 connector for the network cable will not pass through the cable gland on the
underside of the housing. The cable must be cut, threaded through the cable gland and
then re-crimped.
Wire color
Blue
Brown
Yellow/green
Wire color
Red
Blue
7
YP3040 Pan-Tilt Motor
Connect to
24 V AC on power supply
24 V AC on power supply
GND
Connect to
A+ on camera
B- on camera