Mustang MV-TILT3B Manual De Instalación página 2

Mounting the Display Brackets
B
Mounting
Screw
Multi
Washer
CC
C Attaching the display to the wall plate
Note: This procedure will
require two persons
With the Brackets attached
to the display,lift the display
and hook the brackets onto
the Wall Plate as shown.
D Security Option
Padlock
holes
Note: For demonstration purposes, the wall
and the TV have been omitted from the above images.
NOTE:
When attaching the mounting
screws to the display.Make sure
the direction of Bracket is right
M6&M8
and ensure that both brackets
Screw Hole
are vertically alined.
M4&M5
Screw Hole
Top of
Display
Tension
Knob
D.1.
Security Bracket
Recessed Mounting Holes
If the mounting holes are recessed
into the back of the display,use the
supplied spacers to pack the recessed
hole.If the mounting screw is
M4&M5&M6,use the ¢12.7x¢6.0x12.7
mm Spacers.If the mounting screw is
M8,use the ¢19x¢8.0x19.4mm
Spacers.Ensure that the brackets are
securely fixed to the display.
Mounting
Screw
BB
Washer
Bracket
Recessed
Back of
Display
Note:For demonstration purposes,the wall
has been omitted from the above images.
D.1.
Note:The tension knob,
without changing the
bracket tension,can
be pulled out,away
from the bracket and
turned independently
of the knob post for
readjustment.
D.2. For additional security,it is suggested that the
Security Brackets be inserted and a Padlock attached
through Security Bracket and the Wall Plate as shown.
The Padlock(not supplied) should have a shackle diameter
no larger than 5mm(3/16").
Multi
Spacer
Hole
D.2.
Wall Plate
Shackle
5mm(3/16")
diameter
or less
Security
Padlock
Bracket