Operation And Knobs - Klarstein GRENOBLE Manual De Instrucciones

OPERATION AND KNOBS

Plug in the appliance into the socket.
Knob 1 - The function control
• 1st switching position: control the flame simulation
• 2nd switching position: control heating fan, for vent air.
• 3rd switching position: Low heating
• 4th switching position: High heating
• 5th switching position: Power on/off
Knob 2 - Temperature adjustment
• Firstly rotate the temperature control knob clockwise to the maximum value.
Leave the switch in this position until the air in the room has reached the desired
temperature and the thermostat switches itself off.
• Consequently the thermostat will switch the electrical heating on and off in order
to maintain the pre-programmed temperature. This way you will save energy at the
same time.
Knob 3 - Flame effect
Adjust light of fire by rotating the fire adjustable switch clockwise until desired intensity.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g.
due to blocked air vents). For safety reasons, the fire will NOT automatically reset. To
reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and switch on the appliance.
EN
15