Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION:
the coupling to channels and assigning the master are not cancelled by the
N.B.: test mode on the transmitter automatically terminates 3 minutes from activation.
E
2.5 - RECEIVER SETTING FOR OPERATION WITH "MASTER" (if required)
N
NB:
for the
"Master" function
be a chronothermostat
without "Master"
Example with
"Master" function
ON THE MASTER CHRONOTHERMOSTAT activate the "Master Test" mode:
!
"Master" key
Press the
in the chronothermostat manual).
ON THE RECEIVER:
LED 1 is flashing (channel 1 controlled by the "Master")
LED 2 is off (channel 2 independent of the "Master")
!
Hold down
2
key
until a single acoustic signal sounds, then release it.
Both
LED
are flashing
"Master" chronothermostat (fig. 11).
ON THE MASTER CHRONOTHERMOSTAT deactivate the "Master Test" mode:
!
Press the
"Master" key
CANCELLING SETTING FOR "MASTER" FUNCTIONING
ON THE MASTER CHRONOTHERMOSTAT activate the "Master Test" mode:
ON THE RECEIVER
LED 1
and
LED 2
are flashing
!
Hold down
2
key
until a single acoustic signal sounds, then
release it.
LED 2
is off and
"Master" chronothermostat (fig. 12).
ON THE MASTER CHRONOTHERMOSTAT deactivate the "Master Test" mode.
12
a
chronothermostat model with "Master"
or a thermostat.
carried out by the chronothermostat coupled to
until the wording "
" appears on the display, then release it (see chapter
.
Channel 2
is arranged for interlocking to the
.
for 2 seconds, then release it
channel 2
is independent of the
RESET
control or by a power failure.
must be used, whereas the second transmitter can also
channel 1
1
2
1
2
"Assigning Master"
1
2
fig.11
1
2
fig.12
Publicidad
Tabla de contenido
