Perry Electric 1TXRX02/P Datos Técnicos, Instrucciones Para El Instalador, Puesta En Funcionamiento Y Us página 8

1.4 - ATTACHING THE FRONT WITH CARD TO THE BASE
!
Reinsert the front part with card on the base being careful to
correctly insert the pins connecting the card to the terminals.
E
!
N Push the front on to the base using both hands as shown in figure
9.i , until the catches click and lock the front to the base.
Power the receiver and attempt to operate it and couple the
transmitter, as shown in chapter 2 "PUTTING INTO OPERATION
AND USE."
ATTENTION: IN THE EVENT THAT, DUE TO ENVIRONMENTAL CONDITIONS, YOU DETECT AN EXCESSIVELY LOW RADIO
SIGNAL, WE RECOMMEND MOVING THE ANTENNA OUTSIDE THE RECEIVER AND POSITION IT VERTICALLY.
With reference to the installation procedure (chapter 1.2):
SWITCH MAINS SUPPLY
!
Open the receiver
!
Move the antenna wire from its seat (upper inside part of
the front) and rotate it vertically
!
Pass the wire through the small semi-hole provided for the
purpose (fig. 10.I)
!
Carefully reclose the receiver (fig. 9.I - fig. 10.I).
!
Switch on power 230V~
8
230 V~ OFF
1 2
RESET
Antenna factory position
Semi-hole: seat for vertically placed antenna
ON
Fig. 9.i
ON
2
1
RESET
Fig. 10.i