Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75421F
Wrenches: 19mm
Drill Bits: None
Existing
Weld nut
1
Qty. (6)
Hex Bolt M12 X 1.25
1.
1.
Remove the exhaust from its hangers to get better access to frame fastener location.
Remove the exhaust from its hangers to get better access to frame fastener location.
2.
Raise hitch on the passenger side over exhaust pipe and slowly rotate hitch into position.
3.
Secure hitch by loosely installing all the bolts.
4.
Push hitch forward against installed bolts.
Tighten all m12 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
5.
Reattach previously removed exhaust hangers.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005, 2006, 2011 Cequent Performance Products
Installation Instructions
Kia Sedona Van
Frame Rail
Hyundai Entourage
Fascia
Fasteners typical both sides
Do Not Exceed Lower of Towing Vehicle
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1 & SUV2
Frame rail
2
Qty. (6)
Conical Washer
Sheet 1 of 3
75421N
Part Numbers:
75421
44537
70761
78211
U-Haul
Max Gross
Max Tongue
Trailer WT (LB)
WT (LB)
4000 (1816 Kg)
400 (182 Kg)
3500 (1589 Kg)
350 (159 Kg)
4-14-11
Rev. C
Publicidad
Manuales relacionados para Cequent Performance Products 75421
Resumen de contenidos para Cequent Performance Products 75421
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. 2005, 2006, 2011 Cequent Performance Products Sheet 1 of 3 75421N 4-14-11 Rev.
- Página 2 Ne jamais utiliser une torche pour découper un accès ou un trou de fixation. Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. 2005, 2006, 2011 Cequent Performance Products Feuille 2 de 3 75421N 4-14-11 Rev.
- Página 3 No corte el acceso o los orificios del accesorio con soplete. Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684 2005, 2006, 2011 Cequent Performance Products Hoja 3 de 3...