Simons Voss Technologies Z4.KA Folleto De Instrucciones página 8

3. Apply adapter and turn while holding on to the knob
until it can be full pushed onto the core tube.
ð The cross hole of the adapter is flush with the
4. Insert the enclosed pin with the thinner side at the
front of the side through the adapter hole on which
the thread is to be seen.
5. Fasten the pin with a suitable screwdriver.
ð NOTE: The thread may not be destroyed.
6. Make sure that the pin does not protrude on any side
of the adapter.
7. Mount the outside knob with the aid of the installa-
tion tool.
4 Installation Z4.MP.KA.SET
1. Remove the outside knob of the locking cylinder with
the aid of the installation tool.
2. Apply core protection adapter, hold inside knob and
turn until it is flush with the locking cylinder.
ð The grooves of the core protection adapter are
3. Fix the core protection adapter via the enclosed
clamp according to the following illustration:
ð Both markings point in the direction of the core
ð The clamp must snap in correctly with the core
8
SimonsVoss Technologies GmbH
cross hole of the core tube.
now flush with the core tube.
protection adapter.
protection adapter.