Tabla de contenido
Publicidad
4. Installation
• The installation construction should be able to support a minimum point load of 10 times the weight of the device.
• The installation must always be secured with a secondary attachment e.g. a safety cable (VDLSC7 or VDLSC8).
• Install the device outside the reach of unqualified individuals.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• The installation has to be approved by an expert before the device is taken into service.
• The glass pane has to be replaced when it is damaged.
5. Use
1. Connect the stroboscope to the mains and flick the power switch to the ON position.
2. Turn the knob on the backside of the strobe to control the flash frequency (0-15 flashes/sec).
3. Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, the glass pane, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts. Only authorized dealers may maintain and service this device.
7. Technical Specifications
Power Supply
Power Consumption
Dimensions
Total Weight
Fuse
The information in this manual is subject to change without prior notice.
1. Inleiding en kenmerken
Aan alle ingezetenen van de Europese Unie
Belangrijke milieu-informatie betreffende dit product
Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt weggeworpen,
dit toestel schade kan toebrengen aan het milieu.
Gooi dit toestel (en eventuele batterijen) niet bij het gewone huishoudelijke afval; het moet bij een
gespecialiseerd bedrijf terechtkomen voor recyclage.
U moet dit toestel naar uw verdeler of naar een lokaal recyclagepunt brengen.
Respecteer de plaatselijke milieuwetgeving.
Heeft u vragen, contacteer dan de plaatselijke autoriteiten inzake verwijdering.
VDL45ST
max. 230Vac/50Hz
45W
Ø130 x 150mm
0.5kg
2A fast-blow, 250V AC (internal)
VDL45ST – MINI STROBOSCOOP 45W
2
VELLEMAN
Publicidad
Tabla de contenido
