LIM 2 Instrucciones De Manejo página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
PROGRAMMING YOUR OWN COLOUR PROGRAMS
Notice: While programming the changes are visible on the connected RGB-light
unit.
Choosing a program slot
Push the button [Mode] two times to get into the programming mode. The display
shows the following:
Program
USER A
USER B
Editor
USER C
USER D
• Push the button [+]or [-] to choose the desired program slot (in the example
USER A is chosen)
• Confirm pushing the button [Set]. The display shows the following:
USER A
I
R 000
I
G
000
Scene
I
B
000
1
1
I
W
000
Choosing the scene (Scene)
• Push the button [+]or [-] to choose the scene. When a new program is
programmed it is recommended to start with scene 1.
• Confirm pushing the button [Set]. The display shows the following:
USER A
I
R 000
I
000
G
Scene
I
B
000
1
I
W
000
Setting the colour values of each colour channel for a scene
Notes on additive colour mixture:
The additive colour mixture is based on the mixture of the colours red, green and
blue. The values reach from 0-255. If the colours are mixed equally, white light
results. 255 for the human eye distinguishable colours are possible. When the white
colour channel is added the colour saturation decreases.
• Push the button [+] or [-] to choose the desired colour channel.
• Confirm pushing the button [Set].
• Push the button [+] or [-] to set the colour value (0-255) of the chosen colour
channel.
• Push the button [Enter] to confirm your setting.
• Repeat the last four steps for each colour channel.
• Push the button [Enter] to change to the menu point scene. If desired, further
scenes may be programmed.
Notice: Changes of the white colour channel are only visible, when a light unit with
an input for this channel is used and connected.
Limiting the number of scenes
To limit the number of scenes within a program, for example to two scenes, the
colour values of the third scene are simply set to 000. This scene (the third) and the
following are being ignored when running the program.
Closing the programming
To close the programming push the button [Enter] as many times until the controller
gets back to the regular operation mode.
1
Menu point scene
2
Menu point colour
2
channels (Red, Green,
Blue, White)
Example colour chart
R
G
B
colour
000 000 100 dark blue
000 000 255 blue
135 206 235 bright blue
000 100 000 dark green
000 255 000 green
173 255 047 bright green
255 255 000 yellow
255 000 000 red
255 070 000 orange
255 020 147 pink
NOTES
Prog.
Scene
R
G
art.-no. 470531 © 10.01.2013 SLV Elektronik GmbH, Daimlerstr. 21-23, 52531
Übach-Palenberg, Germany, Tel. +49 (0)2451 4833-0
Technical Details are subject to change.
B
Colour

Publicidad

Tabla de contenido
loading

Tabla de contenido