Installation Procedure - urmet domus 1090/809 Manual De Instrucciones

2.2. DIMENSIONS OF THE FASTENING BRACKET (NOT PROVIDED - Ref. 1090/807)
74mm

3. INSTALLATION PROCEDURE

• Identify the point which meets all the correct installation requirements and drill the four bracket fastening
holes. Use suitable fastening devices according to the wall type and capable of supporting a load of at
least 5 kg.
• Fasten the bracket to the wall. To facilitate casing installation operations, position and fasten the fastening
bracket joint as shown in the following fi gures. Turn the screw using the Allen wrench provided to adjust.
10
225mm
74mm
40mm
joint
adjustment
and joint
fastening screw
• Fasten the casing onto the bracket using the two countersunk screws provided.
• Make the roof slide for a few centimetres as shown in the following fi gure to facilitate removing the rear
casing cover.
• Remove the rear cover fastening screws and remove the casing/roof to fully uncover the electronic
board.
rear cover fastening screws
DS1090-132A DS1090-132A
electronic board
PG fairleads
11