urmet domus 1090/809 Manual De Instrucciones página 7

• Disconnect the earth wire Faston connected to the casing.
• Make the casing/roof assembly slide in fully and turn it as shown in the following fi gure.
casing fastening
system
• Turn the camera support.
camera support
12
earth wire
to be disconnected
DS1090-132A
• Install the camera on the support as shown in the following fi gures.
Note: two fastening screws of different length are provided with the casing. Use the most suitable for the
camera.
fastening screw
The casing Ref. 1090/809 can be used to install a camera-lens assembly whose maximum dimensions are
70x70x230mm.
Note: mechanical interference with the heating element may occur with some lens. In this case, try to:
• arrange a shim between the camera and the support (replace the fastening screw, if necessary)
• retract the camera (check quality of pictures).
• Trim and connect the camera power wire (*) to the OUT terminal board. The phase (L), neutral (N) and
earth (symbol) terminals are printed on the printed circuit.
IN terminal board:
power input temperature
sensor
HEATER terminal board:
heater power
(*): if powerable at mains voltage
DS1090-132A
heater
Faston:
earth connections
OUT terminal board:
camera power
13