Installation Instructions - Phase II FabricShade El Manual Del Propietario

Cordless
Pleated
Fabric
Shade
Including
Top Down / Bottom-Up

INSTALLATION INSTRUCTIONS

Step 1. Check Package Contents
Missing part? Call 1-800-264-1190
Mounting hardware kit includes the following:
Part
a. Mounting Bracket
b. 11/8" Screws
c. Handle for Bottom Rail
d. Handle for Middle Rail
(TDBU only)
e. Hold Down Brackets
f. 3/8" Screws for Hold Downs 4
[Note: one extra screw of each noted size is included for convenience]
Step 2. Tools Required
Screwdriver, tape measure,
pencil, drill, drill bits, step
ladder.
Note: use #6 plastic anchors for dry
wall or plaster mounting (not included).
Drill Bits: for screws, use a 3/32" drill bit - for wall anchors, use 1/4" drill bit.
Step 3. Bracket Location and Installation
Your shade may be installed either inside the window frame or
outside the window frame.
A mounting bracket should be positioned about 1" to 6" from
each end of the head rail. For wider shades that require 3 or
more brackets, these should be spaced evenly between the two
outermost brackets. Always position the brackets such that there is
no interference with the cords and mechanisms inside the head rail.
The procedure outlined below will assure proper bracket placement.
Attaching the brackets:
The shape of head rails and mounting brackets varies slightly by size
and style of shade.
style A
For style 'A' [see illustrations]: Lift the head rail into position such that the
inner front edge of the head rail slides into the slot at the front of each
Quantity
2 for shades 18" to 367/8" wide
3 for shades 37 to 477/8"
4 for shades 48 to 72"
2 per bracket
1 for shades up to 597/8" wide
2 for shades 60" to 72"
1 for shades up to 597/8" wide
2 for shades 60" to 72"
2
style B
3