Troubleshooting - Project Source 19551-000 Manual Del Usuario

10. To remove the track head (G) from the track
section (F), first allow the track head (G) to cool
down. Pull down on the track head (G)
connector's locking tab, and twist until the
track head (G) disengages.
CARE AND MAINTENANCE
● Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
● To clean the fixture, use a dry or slightly dampened clean cloth.
● DO NOT use any cleaners with chemicals, solvents, or harsh abrasives as damage to the fixture
may occur.
● 23-watt total LED included; do not attempt to replace the LEDs.

TROUBLESHOOTING

PROBLEM
Light will not turn on.
Blown fuse or tripped circuit
breaker when fixture is
turned on.
WARRANTY
ENERGY STAR qualified Solid State product with non replaceable components is warranted for
five (5) years.
This warranty does not cover parts becoming defective due to misuse, accidental damage, improper
handling and/or installation and specifically excludes liability for indirect, incidental or consequential
damages. Product found to be defective may or may not be replaced with same or like-type product,
contingent on the nature of the defect, and/or replacement availability and/or compensated for at a
pro- rated value. This warranty gives you specific rights and you may also have other rights, which
vary from state to state. Proof of purchase is required to exercise the warranty.
POSSIBLE CAUSE
1. Power is off.
2. Incorrect wiring.
3. Faulty light switch.
4. Connector or track head
may be installed improperly.
1. Incorrect wiring.
Project Source® is a registered trademark of LF, LLC. All rights reserved.
8
10
F
G
CORRECTIVE ACTION
1. Make sure power supply
is on.
2. Check wiring connection at
power source and at track
power feed.
3. Test or replace light switch.
4. Check the connections for
proper installation.
1. Check wiring connection at
power source and at track
power feed.
Lowes.com
Printed in China